Heads/Suits Pieces Ordering Home		Fursuiting :: CloudPouncer Suit Above badge drawn by myself, and id what was used mainly to base the design off for this one. This was my second full suit commission ever for someone else. Balaclava + foam head, moving jaw, usual eyes. Added some white cuffs on the wrists and ankles of this guy for a bit of originality and added cuteness.       Some head only close-up shots. A different type of white fur was used on the head from the body.. the original plan was to use a shorter white for everything, and use just longer fur on the chest. But I ended up using the longer fur all over after making the head.       Here are a few pics of CP in partial suit, worn around a few cons before the bodysuit was complete. The tail is damn near the perfect skunk tail! It stays secure and the means off attatchment remain unseen. How did I make it? Well the 'frame' consists of two, flat aluminum bars, bent to the curvature. It's then shaped with foam and furred. The bars stick out at the base of the tail and slide into a custom made tool belt.. which is easily worn on the inside of a pair of pants, so you never see a thing! Oh, and it's not very heavy either. :)     Some poses in full suit! I was originally planning to use shorter white fur on the body, using the long white only for the chest and tail (hence the head + paws being made with different fur). But then decided the long stuff was just too soft and cuddly NOT to use.. so I used it for the whole body!